Entries to the annual contest close 31st December 2017

19 days to go

Contest entries
A beautiful little siphopteron  S. tigrinum  from a recent trip to PNG.
By Bill Van Antwerp
posted 18:50 CST Today (within the last hour)
Porcupinefish during a night dive
By Andrea Alanis
posted 18:04 CST Today (within the last hour)
A brench of stag horn coral survived after the hurricane.
By Lorenzo Mittiga
posted 17:57 CST Today (1 hour ago)
Nudi laying eggs
By Mario Robillard
posted 17:42 CST Today (1 hour ago)
Diver running a testing schedule on an ROV panel which controls an oil pumping module on the sea bed.
By Mark Dobson
posted 17:16 CST Today (1 hour ago)
Chromodoris magnifica.
By Mehmet Salih Bilal
posted 16:54 CST Today (2 hours ago)


Photo Dive Sites
dive sites latestRuble Tower
Qatar, Persian/Arabian Gulf
dive sites latestKoh dock may
Thailand, Andaman Sea
dive sites latestacqua dive house ...
Philippines, Visayan Sea
dive sites latestShark point
Thailand, Andaman Sea
dive sites latestKho Phi Phi
Thailand, Andaman Sea
dive sites latestSunscape House Reef
Netherlands Antilles, Caribbean Sea
dive sites latestKas Turkey
Turkey, Aegean Sea
dive sites latestMisool Eco Resort...
Indonesia, Banda Sea
dive sites latestKas Turkey, here ...
Turkey, Sea of Marmara
dive sites latestMisool Eco Resort...
Indonesia, Banda Sea

Search Forums

  infoYou are not logged so will not be able to make forum posts until you login or open a member account
  Really Simple Syndication  
message this message is importantHello,

I am new to underwater photography and have access to a 1970s vintage housing originally created by Hugyfot. The housing was later customized by subsequent owners. The original housing did not have an integral tray for mounting strobes. One of the customizations included adding two machined aluminum arms that have flat plates at the top that appear to be intended as a mounting point for strobe arms. However, the plates do not look like any standard system in current use that I recognize.

The plates measure 1" x 2" and are approximately 1/8" thick. There is a pin projecting from one end of each plate. The pin rises approximately 1/16" from the plate surface.

Does anyone recognize the type of mounting system and can offer any information about what adapters I should purchase to use with the housing?

I do have photos available.


 
Paul Hill
19 point member
member image